Fan Assembly. Pgs - Craftmade Enduro END52 5PC1 Serie Guia De Instalacion

5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will keep
the wires together when threading them through
the downrod. [Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread electrical wires through threaded end of
downrod and pull extra wire slack from the upper
end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. [Refer to diagram 2.]
Slide weatherproof yoke cover, canopy cover and
canopy over downrod. [Refer to diagram 3.] (Note:
Canopy cover must be turned with shiny side toward
motor housing. )
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
diagram 1
electrical wiring
downrod
clip
diagram 2
downrod
canopy
canopy cover
diagram 3
page 4
stop pin
hanging ball
yoke set
screw
and nut
pin
weatherproof
yoke cover
motor
housing