Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Enduro END52 5PC1 Serie Guia De Instalacion

8. Blade Assembly.

WARNING: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
one of the hardware packs. Hold blade arm up to blade
and align holes. (Be sure to install blades with
ridged-side facing up and flat side facing the floor).
Insert 3 blade attachment screws (along with washers)
with fingers first and then tighten screws securely with
a Phillips screwdriver. Repeat procedure for the
remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are installed
with blade arm screws, discard plastic motor locks
(save blade arm screws and lock washers to secure blade
arms). Align blade arm holes with motor screw holes
and attach blade arm with lock washers and blade arm
screws. Before securing screws permanently, repeat
this procedure with remaining blade arms. Securely
tighten all screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly (Optional).
Remove 3 screws from switch housing cap (at top of
light kit fitter).
If you wish to use your fan WITH the light kit,
locate BLACK (or BLUE) and WHITE wires in switch
housing labeled FOR LIGHT KIT CONNECTION.
Remove and discard plastic that holds these 2 wires
together.
Connect WHITE wire from switch housing to WHITE
wire from light kit fitter. Connect BLACK (or BLUE)
wire from switch housing to BLACK wire from light
kit fitter. Be sure that molex connections snap
together completely.
Align holes in switch housing cap with holes in
switch housing. Re-insert screws that were previously
removed. ( Note: The gap on the edge of the switch
housing cap must align with the reverse switch on the
switch housing for the proper fit.) Secure all 3 screws
with a Phillips screwdriver.
["Light Kit Assembly" continued on next page.]
plastic
motor
lock
lock washers
molex
connections
page 7
motor housing
blade
blade arm
blade arm
screws
motor housing
switch housing
switch housing cap
light kit fitter