Craftmade Enduro END52 5PC1 Serie Guia De Instalacion página 6

5. Fan Assembly. (cont.)
Thread wires through hanging ball; then slide
hanging ball over downrod--the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw. Insert stop pin into
top of downrod and raise hanging ball. Be sure stop
pin aligns with slots on the inside of the hanging ball.
Tighten set screw securely. [Refer to diagram 4.]
Remove electrical tape from electrical wiring and
thread each of the wires through a different hole in
the weatherproof hanging ball cover. Pull the
weatherproof hanging ball cover down securely over
hanging ball (on downrod). [Refer to diagram 4.]
WARNING: Failure to tighten set screw on hanging
ball completely could result in the fan becoming
loose and possibly falling.
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket. Turn
the hanging ball slot until it lines up with the hanging
bracket tab. [Refer to diagram 5.]
WARNING: Failure to align slot in hanging ball with
tab in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
electrical wiring
stop pin
hanging ball
canopy
diagram 4
diagram 5
page 5
weatherproof
hanging
ball cover
set screw hole
set screw
hanging bracket tab
hanging ball slot