Optional Accessory - Makita HM002G Manual De Instrucciones

To remove the bit, pull the release cover down all the
way and pull the bit out.
1
2
► 1 . Bit 2. Release cover
Bit angle
The bit can be secured at 12 different angles. To
change the bit angle, slide the change ring cover for-
ward, then turn the change ring cover to change the bit
angle. At the desired angle, slide the change ring cover
back to the original position. The bit will be secured in
place.
After changing the bit angle, make sure the angle is
fixed by trying to rotate the bit.
► 1 . Change ring cover

Optional accessory

1.
Loosen the clamp nut, and then remove the hex bolt.
Install the hose holder (A) between the hex bolt and the
clamp nut by tightening the clamp nut firmly.
► 1 . Hex bolt 2. Hose holder (A) 3. Clamp nut
2.
the hose holder (C) to the holder joint.
1
► 1 . Holder joint 2. Hose holder (C)
9 ENGLISH
Dust extractor attachment
Install the hose holder (A).
3
Attach the holder joint to the tool, and then attach
NOTE: The hose joint can be attached to either side
of the tool.
WARNING:
Use the mounting part of the tool
only for attaching the holder joint.
Using the mounting part for any other purpose may
cause an unexpected accident.
1
2
1
2