Telcoma Automations PASSO Instrucciones Para La Instalación página 52

GB
PROGRAMMING – MODIFICATION OF THE OUTPUT RELAY
The receiver's output relays are pulse-type, meaning that they activate
for a second following each correct code. To modify them, proceed as
follows:
press and hold the key for approx. 2 seconds until the keypad be- #
•
eps once.
introduce the MASTER code followed by , the LED
•
51#
enter to modify the channel output 1 of the receiver or
•
dify the channel output 2 (the LED
enter:
•
0# for the Step-by-Step mode that is activated with a correct code
•
and is deactivated after a new correct code
1# for the pulse mode, 1 second
•
2# to 255# for the timer mode where the number corresponds to the
•
seconds the relay remains energized.
The keypad beeps and the LED
Example
I want to program relay 1 with the Step-by-Step output
# 2233# 51#
2 sec. MASTER code command
Example 2
I want to program relay 2 with the timer output at 120 seconds
# 2233# 52#
2 sec. MASTER code command
52
# remains on.
☼
52#
☼ starts to flash).
switches off.
☼
0#
step-by-step mode
120#
number of seconds
to mo-