Telcoma Automations PASSO Instrucciones Para La Instalación página 54

GB
GENERAL RESET
Warning! The reset returns the device to the factory settings therefore can-
celling all codes including the MASTER code that becomes 12345678.
To do this, press and hold the P1 button on the receiver until the red L1
LED lights for a few seconds (detail 2 and 3 of fig. 2) and the keypad
beeps once.
The operation is carried out in about 10 seconds.
IMPORTANT: take care when connecting the communication line. The
wires connected to terminals A and B of the keypad must also be con-
nected to terminals A and B of the receiver.
Do not power the 2 units before checking that the correct voltage has
been selected (detail 3 of fig. 1 and detail 6 of fig. 2)
Check that the 2 units are communicating with one another by pressing
the P2 start button in fig. 2. The LED f on the keypad should light (detail
2 of fig. 1) and beep.
SYSTEM EXPANSIONS OR FAULTS
To replace the keypad (if faulty) or add another to the receiver, proceed
as follows:
Perform the same connections as indicated in the installation chapter.
•
Press the P2 button (detail 4 of fig. 2) of the receiver.
•
The LED ☼ of the keypad flashes and a beep is emitted. In this way
the new keypad is recognised by the receiver.
The codes are not lost because they are contained within the receiver unit.
So as not to loose all memorised codes when replacing the receiver
unit, remove the memory (detail 5 of fig. 2) from the old receiver and in-
sert it into the new one.
54