Invacare InTouch Propel Manual Del Usuario página 10

SECTION 2—INSTALLING
NOTE: Ensure that the back tab is positioned towards the inside of the wheelchair and the round
end is pointing upward.
2. Secure the cane mounting bracket and wedge blocks to the back cane with the two
mounting bolts and hex nuts. Hand tighten securely.
NOTE: Some wheelchairs have adjustable back canes that are both 7/8" and 1". Ensure the wedge
blocks are completely on either the 7/8" or 1" section and not straddling the two. Refer to Detail
"A" in FIGURE 2.2.
NOTE: It may be necessary to raise or lower the back canes to achieve the desired bracket
placement. Refer to Owner's Manual shipped with wheelchair.
3. Repeat STEPS 1 and 2 for the other cane mounting bracket.
NOTE: Cane mounting brackets MUST be parallel to each other.
4. Using the wrench supplied or 7/16 socket wrench, securely tighten the mounting
bolts.
NOTE: DO NOT tighten the mounting bolts until the back height has been adjusted correctly.
NOTE: Check the alignment of the mounting brackets before tightening.
Inside of
Wheelchair
Wedge
Block
Hex Nut
Back Tab
Hex Nut
Cane
Mounting
Bracket
™ ™
InTouch Propel Back
Wedge
Block
FIGURE 2.2 Installing Mounting Hardware
Back Cane
Outside of
Wheelchair
Mounting
Bolts
NOTE: Measure
same distance on
both sides.
10
DETAIL "A" -
ADJUSTABLE BACK
CANES
7/8" section
1" Section
Part No 1143199