Specifications; Standard Equipment; Pre-Operation Inspection - RIDGID K9-306 FlexShaft Manual De Instrucciones

FlexShaft™ Drain Cleaning Machine
XXXXXXXXMMYY
Figure 2 – Machine Serial Number
Serial number plate is located on cart side
of housing. (See Figure 1A) The last 4 digits
indicate the month (MM) and year (YY) of
manufacture.

Specifications

Drain Capacity
(Nom.) ...................3" to 6" (75 – 150 mm)
Cable Diameter
(without Sheath) .....3/8" (9.5 mm)
Cable Assy. Diameter
(with Sheath) ......... 5/8" (15.9 mm)
Cable Assembly
Length ................... 125' (38.1 m)
Motor
Power ....... 1.1 kW (1.5 HP) 1.1 kW (1.5 HP)
Voltage ..... 110-120V
Current ..... 11A
Refer to on product serial plate for information specific to unit.
Rotational Speed ...2000 RPM
Weight ....................159 lbs. (72 kg)
Dimension .............. 36.1" × 32.5" × 20.5"
Operating
Temperature ........... 20°F to 140°F
Sound Pressure
(L )* ......................96.1 dB(A), K=3
PA
Sound Power
(L )* .....................91.8 dB(A), K=3
PW
* Sound measurements are measured in accordance
with a standardized test per Standard EN 62481-1.
. - Sound emissions may vary due to your location and
specific use of these tools.
. - Daily exposure levels for sound need to be evaluated
for each application and appropriate safety measures
taken when needed. Evaluation of exposure levels
should consider the time a tool is switched off and not
in use. This may significantly reduce the exposure level
over the total working period.

Standard Equipment

Refer to the RIDGID catalog for details on e-
quipment supplied with specific drain cleaning
machine catalog numbers.
6
220-240V
8A
(918 mm × 826 mm ×
521 mm) Handle down
(-6°C to 60°C)
This machine is made to clean
NOTICE
drains. If properly used it will not damage a
drain that is in good condition and properly
designed, constructed and maintained. If the
drain is in poor condition, or has not been
properly designed, constructed and main-
tained, the drain cleaning process may not be
effective or could cause damage to the drain.
The best way to determine the condition of
a drain before cleaning is through visual in-
spection with a camera. Improper use of this
drain cleaning machine can damage the drain
cleaning machine and the drain. This machine
may not clear all blockages.

Pre-Operation Inspection

WARNING
Before each use, inspect your Drain
Cleaning Machine and correct any prob-
lems to reduce the risk of serious injury
from electric shock, twisted or broken
cables, chemical burns, infections and
other causes and prevent Drain Cleaning
Machine damage.
Always wear safety glasses, and other
appropriate protective equipment when
inspecting your Drain Cleaning Machine.
1. Make sure that the drain cleaning ma-
chine is unplugged and inspect the
power cord, Ground Fault Circuit Inter-
rupter (GFCI) and plug for damage. If
the plug has been modified, or if the cord
is damaged, to avoid electrical shock,
do not use the machine until the cord
has been replaced by a qualified repair
person.
2. Clean the machine, including handles
and controls. This aids inspection and
helps prevent the machine or control
from slipping from your grip. Clean and
maintain the machine per the mainte-
nance instructions.
3. Inspect the machine for:
• Proper assembly and completeness.
• Any broken, worn, missing, misaligned
or binding parts.
• Presence and readability of the warning
label (see Figure 3).
999-995-214.10_REV. A