Battery
Battery
Minus (-)
Battery
Battery
Plus (+)
1.5 Badge Option: Activation of the Patient Badge, OPTIONAL Equipment
The patient badge comes with a preinstalled
battery. The battery has not been factory
activated in order to preserve battery life. On
the backside of the badge, locate the circle
about ½ inches in diameter with the inscription
START located near the middle of the badge.
Hold the badge firmly with one hand and with
the other hand use a finger to press the circle
firmly for 6 to 7 seconds. The badge should
now be active and ready for use
1.6 System Learn Mode
Before the caregiver receiver can operate with the patient badge or fob, it must first learn
the badge or fob ID code. Place the badge or fob 2 – 3 feet away from the caregiver
receiver. Refer to figure 6. Turn on the caregiver receiver (refer to figure 1). Wait for
receiver to initialize, indicated when the two LED's stop flashing. Locate the "Reset-Learn"
button on the caregiver receiver. Hold caregiver receiver in the upright position and press
down on the 'Reset/Learn" button switch. Hold the button down until an audible beep is
heard from the caregiver receiver. Within 3 to 15 seconds a second audible sound (a long
beep) should be heard. This indicates the receiver has learned the badge/fob code. If the
receiver starts to alarm, repeat the learn function. If the alarm condition continues, consult
the Trouble shooting section of the User's Manual
DT COMM Inc.
Slide Into Holder,
Slide Into Holder,
Minus Side
Toward Board
Toward Board
Figure 4. Inserting the Battery
7
Battery
Battery
Holder
Holder
PB101A Patient Badge Tag
PB101A Patient Badge Tag
My Name Is
My Name Is
My Name Is
Jean Doe
Jean Doe
Jean Doe
Figure 5, PB101A Hanging Badge
IF Found Please Contact
IF Found Please Contact
IF Found Please Contact
1) 408 - 555 - 1000
1) 408 - 555 - 1000
1) 408 - 555 - 1000
2) 408 - 555 - 6000
2) 408 - 555 - 6000
2) 408 - 555 - 6000
3) 800 - 555 - 2000
3) 800 - 555 - 2000
3) 800 - 555 - 2000
Start
Start
Start
Version 1.4