Care And Maintenance - PROFLO PF9002SWH Instrucciones De Instalación

InstallatIon InstructIons
skIrted het two pIece toIlet

Care and Maintenance

When cleaning your toilet, wash it with mild,
soapy water, rinse thoroughly with clear
water and dry with a soft cloth.
Avoid detergents, disinfectants or cleaning
products in aerosol cans.
NEVER use abrasive scouring powders or
abrasive pads on your toilet seat. Some
bathroom chemicals and cosmetics may
damage the seat's finish.
CAuTION: Product is Fragile. To avoid break-
age and possible injury handle with care!
DO NOT use abrasive powder or liquid
cleaners which can damage the product
surface. Over tightening of the lock nut
or coupling nut could result in breakage
and flooding.
Adjustable
Rod
Fill valve body
Float Cup
Triangle Gasket
Rubber Seal
Plastic Seal
Hexagon Seal
DO NOT use the cone washer with a plastic
supply line.
DO NOT use pipe dope or other silicon based
materials to tighten supply coupling nut.
NOTE: All trouble shooting should be done by a
qualified plumbing technician.
Install Tank Lid and Seat
1. Gently set the lid on the toilet tank.
2. Install the toilet seat to the specifications of
the seat supplier or manufacture.
Tank Replacement Part Information
The inside back of your tank is stamped with
replacement part information. Please record
and maintain this record for future maintenance
and reliable service of your new toilet.
Problem Reason
Fill Valve will not fill. Fill Valve will not fill?
Float valve is stuck?
Drain Guards are stuck?
Fill valve will not Water supply continues to run?
shut off.
Float is stuck?
Flapper is stuck open?
Leakage. Fill valve nut is loose?
Flapper is not seated properly?
Flapper is not seated properly?
Poor Flush. Water level is not set to
proper height?
Low water pressure?
Obstruction in bowl?
Short Flush?
WARNING
!
DO NOT uSE IN-TANK
TOILET BOWL CLEANERS
CONTAINING BLEACH
OR CHLORINE!
1. Result in damage to tank components and
may cause flooding and property damage.
2. Void PROFLO Fixtures Limited Warranty.
Solution
Turn on water supply at angle stop valve.
Loosen fill valve nut and turn fill valve away from back of tank.
Clean drain guard of debris.
Turn off water and clean the inside fill valve.
Loosen fill valve nut and turn fill valve away from back of tank.
Check chain length and flush valve seat.
Check the flush valve is tightened into place.
Check hex nut on fill valve to assure it is tight.
Clean flush valve seat, replace flapper if necessary.
Adjust the water level set screw to assure water is at the
maximum level line.
Make sure the minimum water pressure is above 35 PSI.
Plunger the bowl and clean the drain line as necessary.
Adjust the chain length of the flapper.