Descaling Procedure - Philips Saeco INCANTO HD8922 Manual Del Usuario

English
20

Descaling procedure

1 Pour the contents of the milk circuit cleaner sachet in the milk carafe.
Then fill the milk carafe with water up to the MAX level indication.
2 Insert the milk carafe into the machine and place a container under the
milk dispensing spout.
3 Press the MENU button, select DRINKS and scroll to MILK FROTH. Press
the OK button to start dispensing the cleaning solution.
4 Repeat step 3 until the milk carafe is empty.
5 When the carafe is empty, remove the container and the milk carafe from
the machine.
6 Rinse the milk carafe thoroughly and fill it with fresh water up to the MAX
level indication.
7 Insert the milk carafe into the machine.
8 Place the container under the milk dispensing spout.
9 Press the MENU button and select MILK FROTH in the DRINKS menu to
start the carafe rinsing cycle.
10 Repeat step 9 until the milk carafe is empty.
Note: Never drink the solution dispensed during this step.
11 Repeat steps 6-10.
12 When the machine stops dispensing water, the cleaning cycle is finished.
13 Disassemble all the components and rinse them under a lukewarm tap.
The machine is ready for use.
When the display shows START CALC CLEAN, you need to descale the
machine. If you do not descale the machine when this message appears on
the display, the machine will eventually stop working properly. In that case,
repairs are not covered by the warranty.
Please use Philips Saeco descaler only. Under no circumstances should you
use a descaler based on sulfuric acid, hydrochloric acid, sulfamic or acetic
acid (vinegar) as this may damage the water circuit in your machine and not
dissolve the limescale properly. Not using the Philips Saeco descaler will
void your warranty. Failure to descale the appliance will also void your
warranty. You can buy Philips Saeco descaling solution in the online shop at
www.saeco.com/care.
The descaling procedure lasts 30 minutes and consists of a descaling cycle
and a rinsing cycle. You can pause the descaling or rinsing cycle by pressing
the escape button. To continue the descaling or rinsing cycle, press the OK
button.
Note: Do not remove the brew group during the descaling procedure.
Warning: Do not drink the descaling solution or the water
dispensed during the descaling procedure.
1 Remove the drip tray and the coffee grounds container, empty and clean
them and put them back into place.
2 Place a large container (1.5 l) under the coffee dispensing spout.