Philips Saeco INCANTO HD8922 Manual Del Usuario página 25

Problem
I cannot remove the brew
group.
I cannot insert the brew
group.
The coffee has too little
crema or is watery.
Coffee is leaking from the
coffee dispensing spout.
The coffee is not hot
enough.
Cause
The brew group is not in the
correct position.
You have not removed the
coffee grounds container.
The brew group is not in the
correct position.
The machine is still in the
descaling procedure.
The grinder is set to a too
coarse setting.
The coffee blend is not the
correct one.
The machine is performing its
self-adjustment procedure.
The brew group is dirty.
The coffee dispensing spout is
clogged.
The coffee exit duct is clogged. Clean the coffee exit duct.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
Solution
Close the service door. Switch the
machine off and back on again. Wait for
the 'machine ready' screen to appear
and then remove the brew group.
Remove the coffee grounds container
before you remove the brew group.
You did not put the brew group in the
correct position before placing it back.
Make sure that the lever is in contact
with the base of the brew group and that
the hook of the brew group is in the
correct position.
Reset the machine in the following way:
place the drip tray and the coffee
grounds container back. Leave the brew
group out. Close the service door and
switch the machine on and off. Then try
to reinsert the brew group.
You cannot remove the brew group
when the descaling procedure is active.
First complete the descaling process
and then remove the brew group.
Adjust the grinder to a finer setting.
Change the coffee blend.
Brew a few cups of coffee.
Clean the brew group.
Clean the coffee dispensing spout and
its holes with a pipe cleaner.
Preheat the cups by rinsing them with
hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
English
25