Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Locate the existing hole locations shown below. There will be two sets of hole locations (Front, Rear). (Fig. 2 & 3)
Driver inner
Front driver
Fig. 2
2
Select (1) 8mm Bolt Plate, and (1) Plastic Retainer (small hole). Partially thread the Retainer onto the Bolt Plate. Insert
the Bolt Plate into the Driver side front outer mounting location. Select (1) 8mm Offset Bolt Plate, and (1) Plastic Retainer
(small hole) Partially thread the Retainer onto the Offset Bolt Plate. Insert the Offset Bolt Plate into the Driver side front inner
mounting location. Thread the Retainers until tight against floor panel. Hang Driver side front bracket from bolts with (2)
3
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
Outside of vehicle
Driver outer
8mm Flange Nuts. Do not tighten hardware at this time. (Fig. 4 & 5)
Holes utilized
Driver inner
Fig. 4
Fig. 5
Page 3 of 5
Outside of vehicle
Driver outer
Rear driver
Fig. 3
Publicidad
