Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Select (1) 8mm Bolt Plate, and (1) Plastic Retainer (small hole). Partially thread the Retainer onto the Bolt Plate. Insert the
Bolt Plate into the Driver side rear outer mounting location. Select (1) 10mm Large Bolt Plate, and (1) Plastic Retainer (large
hole). Partially thread the Retainer onto the Large Bolt Plate. Insert the Large Bolt Plate into the Driver side rear inner mount-
ing location. Thread the Retainers until tight against floor panel. Hang driver side rear Bracket from bolts with (1) 8mm
Flange Nut (outer) and (1) 10mm Flange Nut (inner). Do not tighten hardware at this time. (Fig. 6 & 7)
4
Using the bracket configuration for the application needed (shown in Step 1), place End Plate bracket onto the correct
location on Front Bracket and bolt together using a 8mm flange bolt and a 8mm flange nut (Fig. 8). Repeat for the
rear bracket location, again using the correct location from Step 1. Place running board on End Plate bracket and start
5/16" flange nuts onto each of the bolts found in the running board. Do not completely tighten. Rotate running board
upwards and then place the remaining two 8mm flange bolts and the two 8mm flange nuts (per bracket location).
5
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
Fig. 7
Fig. 8
Page 4 of 5
Fig. 6
Publicidad
