Mutsy EVO Manual De Instrucciones página 17

Adjust the back support (r)
· Pull the button at the back of the seat upwards and hold it upwards.
· The back support has 4 positions. Place the back support in the desired
position and release the button to lock the position.
Adjust the leg support (s)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the leg support and push the leg
support downwards to lower it.
Reclined carriage position (t1,t2)
· The seat has a reclined carriage position to make the seat suitable for
children from birth.
· ! The use of a suitable pram body is always recommended and preferred
for children from birth up to the age that your child can sit up unassisted.
· To put the seat in the reclined carriage position, put the leg rest in its
highest position and the backrest of the seat in its fully reclined posi-
tion. Release the two press studs on each side of the seat. (t1)
· Open the zipper around the leg support. There is a fabric side support
in the pocket behind the leg support, which you can pull out. Now you
can put the side support up and attach the press stud on each side
onto the plastic shell of the seat. The press studs of the seat cover can
now be attached to the press studs of the side support. (t2)
· ! Make sure that the canopy is properly attached to the velcro at the top
of the backrest.
· Attach and remove bumper bar (u)
· Push the ends of the bumper bar in the thereto designated notches in
the seat until you hear a click.
· Press the unlock buttons on both sides of the bumper bar and remove
the bumper bar from the seat.
The integrated foot step (w)
· There is a zipper around the leg support of the seat. If so desired you
can open this zipper to thus create a higher foot rest for your child. The
child can then place the feet on the aluminium bar of the leg support.
When you child gets bigger you can again close the zipper and your
child can place the feet on the plastic foot rest of the frame.
The hood (v1, v2)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood. (u1)
· Open the zipper in the centre to further enlarge the hood. Close the
EN
11