Rear Panel; Speaker Outputs - Peavey PVi 4B Guia De Inicio Rapido

Rear Panel

5
6

(1) SPEAKER OUTPUTS

These are two-conductor 1/4" speaker outputs. Each one is rated at 8 ohms minimum impedance. Total
minimum load for the amplifier is 4 ohms. You may connect either one 4-ohm, one 8-ohm or two 8-ohm
speakers. Do not operate below rated minimum impedance. Be sure to use speaker cables and not
instrument cables to connect to the speakers.
(2) LINE OUT
This is a 1/4" two-conductor line output. It is used to connect the PVi™4B to an additional power
amp or to send a submix to a larger P.A. system. This line-level signal is a mirror image of the main
outputs.
(3) TAPE OUT (L/R)
These RCA output jacks are primarily intended for connecting a tape deck, MP3, or other device for
the purpose of recording from the mixer. Both channels are summed into mono for compatibility. The
signals are taken pre-master section, meaning that they are without reverb or the master tone section,
and do not include the Tape-In signal. If you wish to record with the reverb and Tape In signals, use
the 1/4" line output (2) with the proper cable.
(4) TAPE IN (L/R)
These RCA jacks are for connecting a cassette deck, CD player or other line-level source.
(5) POWER LINKING CONNECTOR
This is a standard IEC cable connector for use with standard voltages from AC wall outlets. It is
grounded and should never have the ground pin removed for any reason. The IEC connector contains
an internal fuse holder. The fuse rating is 5 amperes.
(6) POWER SELECT SWITCH
This switch must be set properly for the local AC line voltage. Either 115 (110-120 VAC) or 230 (220-240
VAC) selections are selectable by this switch.
1
WARNING
THE ON/OFF SWITCH IN THIS APPARATUS
DOES NOT BREAK BOTH SIDES OF THE MAINS.
HAZARDOUS ENERGY MAY BE PRESENT INSIDE
THE ENCLOSURE WHEN THE POWER SWITCH IS
IN THE OFF POSITION.
7
2 3 4