JUST ONE HELMET J12 Instrucciones De Uso página 25

PEAK : ADJUSTING
see fig. 3.1 - 3.2 - 3.3 - 3.4
Remove the cover on the peak by a slight pressure by
inserting a small screwdriver into the slots at the rear of
the cover (see fig. 3.1).
Loosen without removing the two screws on the right
and two on the left and that one on the central part (see
fig.3.2). Adjust the position of the front part rotating it
upwards or downwards until the desired position is ob-
tained. After finding the position, tighten the three screws
and re-check the position of the front part.
Put the lid back on the peak from the front and then ap-
ply pressure to the rear until it locks into place (see Fig.
3.3 – 3.4).
For all these operation, use the proper tool to tighten
these screws.
j U S T O N E H E L m E T S . C O m
USER'S INSTRUCTIONS
3.1
3.3
3.2
3.4
EN
25