JUST ONE HELMET J12 Instrucciones De Uso página 26

USER'S INSTRUCTIONS
EN
PEAK : REPLACING
see fig. 3.A - 3.B - 3.C - 3.D
Remove the cover on the peak by a slight pressure by
inserting a small screwdriver into the slots at the rear of
the cover (see fig. 3.A).
Loosen and remove the two screws placed on the right
and two on the left and one on the central part(see
fig.3.B). Position the new front part by making the holes
match with the five threaded fittings on the shell. Insert
the screws in the specific housings without tightening
completely. Adjust the position of the front part and lock
it into position as indicated in above paragraph.
Put the lid back on the peak from the front and then ap-
ply pressure to the rear until it locks into place (see Fig.
3.C – 3.D).
For all these operation, use the proper tool to tighten
these screws.
26
3.A
3.C
j U S T O N E H E L m E T S . C O m
3.B
3.D