Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section D - Existing Construction – accessible from below
D2
D1
Remove one of the wiring access slugs on the top of the
Remove the mounting rail brackets.
housing. Use a second wiring access plug if needed.
D3
D4
EXISTING FAN
3"
Remove an existing fan and check to make sure the opening
Run the power supply wire through the strain relief, leaving 3"
is large enough to accommodate the new fan housing. If
between the end of the wire and the strain relief. Tighten the
there is no existing fan choose an appropriate location to
strain relief around the wire.
12
make an 11" x 9 5/8" opening.
43044-01 03/05/2008
Publicidad
Tabla de contenido
