Unpacking Instructions - Fanimation The Ventana FP8032DZ Manual De Instrucciones

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• Three wire connectors (supplied)
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 9). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
!
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
HANGER
BRACKET
ASSEMBLY
W/SCREWS
DOWNROD/
HANGER BALL
ASSEMBLY
CEILING
CANOPY
Hand-held
Remote
• One wire stripper
• One 1/4" blade
screwdriver
WARNING

Unpacking Instructions

WARNING
CANOPY
SCREW
COVER
ASSEMBLY
MOTOR
COUPLING
COVER
FAN MOTOR
ASSEMBLY
RECEIVER
UNIT
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
• Fan Motor Assembly
• Hanger Bracket Assembly with
screws
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Blade Holder Set
• Blade Set
• Light Plate Assembly
• Socket Plate Assembly
• Light Bulb
• Glass
• Hand-held Remote
• Receiver Unit
LIGHT PLATE
ASSEMBLY
SOCKET
PLATE
ASSEMBLY
BLADE SET
BLADE HOLDER SET
4
Materials
Wire Size A.W.G.
14
12
• Hardware bags:
– 3/16˝-24 Washer Head Screw
(blade to blade holder)
– 3/16˝ Fiber Washer
(blade to blade holder)
– 1/4˝-20 Pan Head Screw
(blade arm to motor)
– Phillips Screwdriver, 4˝
– Four Wire Connectors
– Balance Kit
GLASS
LIGHT BULBS
HARDWARE BAG