Operations - Bissell CLEANVIEW 14522 Serie Guía Del Usario

Operations

power switch
The Power switch on models 14522 is located
on the front of the handle. Push the button
once to vacuum, and push the button
when cleaning is complete.
notE: you can find your model number on the
back, bottom side of the vacuum on the white
sticker by the Ul rating.
handle position
Press the handle release pedal with your foot
to place your CleanView vacuum into one of
three cleaning positions.
1. Upright – For storage and above floor
cleaning with tools.
2. Normal cleaning – Press handle release
for household floor cleaning tasks.
3. Low cleaning – With the vacuum in
normal cleaning position, press handle release
pedal again, use for reaching under low furniture
such as tables, chairs or beds.
height adjustment
There are five height settings available for
various floor surfaces. Turn the dial on the foot
of the cleaner to the desired setting.
Lowest setting – For low pile carpet or bare
floors. To pick up debris, it may be necessary
to move up one setting.
Medium setting – For medium pile carpet.
Highest setting – For high pile and most
shag carpet.
notE: for optimal carpet cleaning performance,
adjust to the lowest practical setting. If your
cleaner is difficult to push, adjust to the next
higher setting.
if the dial is difficult to turn, tilt the cleaner
back slightly to take the weight off the foot
while turning.
transporting cleaner
1. To move your cleaner from room to room, put
the handle in the upright position, tilt the cleaner
back on its rear wheels and push forward.
2. The cleaner can also be moved by using the
carrying handle.
Tips
*Product images may vary
» Hair, string and small objects can block the
vacuum hose or tools. Check them occasionally
for obstructions.
again
» Before cleaning under low furniture, check area
first for objects that might harm the unit or block
the vacuum hose.
caUtIon
Before using your vacuum, make sure that the dirt
tank is in the locked position and that both filters
(pre-motor and post-motor) are in place. Do not
operate your vacuum without these filters.
www.bissell.com
7