Troubleshooting - Bissell CLEANVIEW 14522 Serie Guía Del Usario

Troubleshooting

problem possible causes
Vacuum
Power cord not plugged in
cleaner won't
blown fuse/tripped breaker
turn on
incorrect height adjustment
Hose not attached to suction
opening
Crack or hole in hose
broken or worn drive belt
Rotating floor brush bristles worn
Vacuum
Rotating floor brush jammed
cleaner won't
pick up dirt
Clog in vacuum
Dirt tank full
Dirt tank or upper tank not
installed properly
Filters are dirty
Crack or hole in hose
Clog in vacuum
tool won't
Dirt tank full
pick up
Dirt tank or upper tank not
installed properly
Filters are dirty
Vacuum cleaner
incorrect height adjustment
difficult to push
Dirt tank full
Visible dirt
escaping from
Filters missing or installed
cleaner
incorrectly
cord will
Knotted or twisted
not retract
please do
not return
this product
to the store.
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a bissell product.
for any questions or concerns, bISSEll is happy to
be of service. contact us directly at 1-800-237-7691.
WaRnInG
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Check electrical plug
Check/replace fuse or reset breaker
Adjust powerfoot to correct height setting
Grasp the hose wand and firmly push
into the hose wand base
Check hose and replace if needed
Replace drive belt, see page 11
Replace brush
Remove brush and clean debris from
brush ends, see page 11
Follow instructions on page 12 for
clearing clogs
empty dirt tank
Position correctly and lock in place
Check and clean or replace pre-motor
and post-motor filters, see pages 9-11
Check hose and replace if needed
Follow instructions on page 12 for
clearing clogs
empty dirt tank
Position correctly and lock in place
Check and clean or replace pre-motor
and post-motor filters see pages 9-11
Adjust powerfoot to correct
height setting
empty dirt tank
Check pre-motor and post-motor
filters for correct installation
Follow instructions on page 8
www.bissell.com
13