Assembly - Hanging the Fan
3
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock,
or other personal injury, mount the fan to an outlet
box or supporting system marked acceptable for fan
support and use the mounting screws provided with
the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting plate on the outlet box by sliding the
mounting bracket (A) over the two screws (HH) provided with the
outlet box. If necessary, use leveling washers (not included) be-
tween the mounting bracket (A) and the outlet box. Note that the
flat side of the mounting bracket (A) is toward the outlet box.
□
Securely tighten the two mounting screws (HH).
HH
4
Hanging the fan
WARNING: The hook as shown is only to balance fan
while attaching wiring. Failure to hang as shown may
result in hook breaking, causing the fan to fall. Hook
must pass from inside to outside of canopy.
□
Carefully lift the fan motor assembly (D) up to the mounting
bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
mounting bracket (A) socket is properly seated in the groove
in the hanger ball. If using close-to-ceiling mounting, hang the
fan on the hook provided by utilizing one of the holes at the
outer rim of the ceiling canopy.
A
9
Please contact 1-855-HD-HAMPTON for further assistance.
A
D
A
B
D
HAMPTONBAY.COM