Glass Bowl - HAMPTON BAY 91371 Guía De Uso Y Mantenimiento

Assembly - Assembling the Fan Without the Light Kit
14
Installing the bulbs and attaching
the glass bowl
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the glass to break.
WARNING: Over lamping the fan will result in the fan lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off, replace bulbs with the correct
wattage bulbs, turn on.
□
Remove the rubber washer, hex nut, bottom cover and finial
from the threaded nipple of the light kit fitter assembly (E).
□
With power off, install the two LED bulbs (Max. 9W,
included) (I) by screwing into the light bulb sockets.
□
Position the glass bowl (H) over the threaded nipple.
□
Re-install the rubber washer, hex nut and bottom cover to
the threaded nipple to secure the glass shade properly.
□
Re-install and tighten the finial.
I
15
□
In order to use the fan without the light kit, remove the switch
cup cover from the top of the light kit fitter assembly (E) by
removing the center hex nut inside the switch cup cover, and
then thread the switch cup cover off of the threaded nipple
on the top of the light kit fitter assembly (E). Remove three
screws.
□
Press the plastic plug (EE) (provided) into the center hole of the
switch cup cover.
□
Align the three screw holes in the switch cup cover with the
three key slots in the switch cup. Make sure the notch in the
switch cup cover clears the reversing switch in the switch cup.
□
Position the switch cup cover onto the switch cup and install
the three screws that were removed in first step.
□
Turn the switch cup cover clockwise until it locks and tighten
the three screws.
D
E
H
14
Assembling the fan without the
light kit