Proscenic CocoSmart 880L Manual Del Usuario página 11

Trouble Shooting
voice prompt
1, Please put back the
dust box and filter
2, Please move the rob-
ot to the horizontal gro-
und to start
3. Please check the falla-
rrest sensors and move
the robot to a new posi-
tion to start
4, Please clean the right
wheel
5, Please clean the left
wheel
6, Please clean the side
brush
7, Please clean the main
brush
8, Please place the robot
on the ground to start
9, Please clear the obst-
acle around the charging
base
10, Please wipe the front
infrared sensor and move
the robot to a new posi-
tion
11，Please check if the
edge sensor needs cleaning.
12, The collision bumper
is abnormal, please check
if you need to clean it.
13, Please clear the obsta-
cles around the robot and
try again.
Note: Rebooting the robot can solve some problems.
Indicators
Clean button and Recharge button
blink:they will slowly blink three
times then quickly blink once.
Clean button and Recharge button
blink:they will slowly blink once
then quickly blink once.
Clean button and Recharge button
blink: they will slowly blink twice
then quickly blink twice.
Clean button blinks: it will slowly
blink once then quickly blink twice.
Clean button blinks: it will slowly
blink twice then quickly blink once.
Clean button blinks: it will slowly
blink three times then quickly blink
once
Clean button blinks: it will slowly
blink once then quickly blink once
Solution
Please try to replace the filter and confirm
that the filter and dust box are in place. If
the problem remains, please try to replace
the filter again.
The robot is tilted at startup, please put the
robot on the horizontal ground to restart;
The robot suspends. Please move it to anot-
her position and restart it ; Dirty fall-arrest
sensors may cause the fault, so please wipe
them with soft rag
The right wheel is entangled with garbage.
Please remove garbage.
The left wheel is entangled with garbage.
Please remove garbage.
The side brush is entangled with garbage.
Please disassemble the side brush and clean
it;
The main brush may be entangled with
gargage. Please remove it and its bearing
to clean.
The wheels are suspended. Please place the
robot on the ground to start.
Please clear the obstruction or other objects
around the charging stand; if these cannot
be cleared, please move the charging stand
to a new position.
Please wipe the infrared sensor with a dry
cloth, and clear the obstruction or foreign
objects around the robot. If they cannot be
cleared, please move the robot to a new po-
sition to start.
The edge sensor is covered by dust, please
wipe the sensor;
The collision bumper is stuck. Please tap it
for several times to remove foreign objects.
If there is no foreign objects, please move
the robot to another position to start.
The robot may be stuck or trapped. Please
clear obstacles around it.
10