Care And Cleaning; The Outside - GE PZS22MMKES Manual Del Propietario E Instrucciones De Instalación

Ice and Water Dispenser
Precise Fill
(on some models)
This water dispenser is equipped with a feature called
amount of water (cups or ounces) that you would like
models.
Touch LED Dispenser Control:
1. Press the PRECISE FILL CUPS/OZ pad. The
WATER pad will light and the CRUSHED and
CUBED ice pads will turn off. The last unit used will
be displayed.
2. Press the PRECISE FILL pad again to toggle
between cups and ounces.
If you selected OUNCES, press the
select the number of ounces you would like to have
dispensed between 2–99 ounces. The default is 8
ounces.
Important Facts About Your Dispenser
glasses. Backed-up ice can jam the chute or cause
the chute, poke it through with a wooden spoon.
in the ice storage drawer. Cans, bottles or food
packages in the storage drawer may cause the
icemaker or auger to jam.
the glass close to, but not touching, the dispenser
opening.

Care and Cleaning

Cleaning the Outside
The dispenser drip area,
beneath the grille, should be
wiped dry. Water left in this
area may leave deposits.
Remove the deposits by adding undiluted vinegar to the
well. Soak until the deposits disappear or become loose
enough to rinse away.
20
(on some models)
If you selected CUPS, press the
select the amount you would like to have dispensed.
They are displayed as 1/4, 1/3, 1/2, 2/3 and 3/4, with
the highest amount being 16 3/4 cups. The default is
1 cup.
3. Press the cup against the cradle and water will
the amount set has been dispensed. The display
will show the amount of water dispensed, beep,
then reset after 5 seconds.
NOTE:
is being dispensed.
or pad to
specified amount has been dispensed, just remove the
cup from the cradle. The display will show the amount
switch is pressed again within that time, the dispenser
will return to the set amount.
you selected CUBED ice. This happens occasionally
when a few cubes accidentally get directed to the
crusher.
from the chute.
door in the ice chute. This condition is normal and
usually occurs when you have dispensed crushed ice
repeatedly. The snow will eventually evaporate.
The dispenser cradle. Before cleaning, lock the
dispenser by pressing and holding the LOCK CONTROLS
or LOCK pad for 3 seconds. Clean with warm water and
baking soda solution—about a tablespoon (15 ml) of
baking soda to a quart (1 l) of water. Rinse thoroughly
and wipe dry.
or pad to
49-60647 Rev. 8