STACK-ON GCB-5300RTA Manual De Instrucciones página 3

3. Assemble the Top Panel (which has the Stack-On Name Plate). This will
assemble the same as the Bottom Panel.
With the front and back flanges on the outside of the cabinet and the side
flanges on the inside of the cabinet, assemble with (10) Carriage Bolts, Lock
Washers and Nylon Locking Nuts. (See Figure 3)
Now tighten all the fasteners in the cabinet body. Do not over tighten.
TOP PANEL
Figure 3
5. The Door can be assembled on the left or right.
Depending on where you are going to place your
cabinet, you may want your Door to open in a certain
direction. Review the section "Selecting a Location"
and determine the opening direction before
assembling the Door.
Align the door hinge holes with the cabinet holes.
Assemble with (8) Large Screws and Flange Nuts.
(See Figure 5)
Center the Door in the opening (from top to bottom)
and tighten the screws.
CARRIAGE
BOLT
LOCK
WASHER
4. SHELF ASSEMBLY
(OPTIONAL)
NYLON
There are 4 sets of holes
LOCKING
NUT
providing 4 different shelf
height options for your (3)
Shelves. Assemble each
Shelf using (4) Small
Screws and (4) Locking
Nuts (See Figure 4).
LOCKING
NUT
SMALL
SCREW
4 SHELF
POSITION
OPTIONS
FOR 3
SHELVES
Figure 4
DOOR
FLANGE
NUT
LARGE
SCREW
Figure 5 3 21
40155-1204