osann LUX Isofix Manual Del Usuario página 10

EN
Installation with Isofix bracket
•
This child car seat is a child restraint system of the category „Semi-Universal"
and fits into all vehicles which are suitable for the installation of a „Semi-Uni­
versal" child restraint system.
•
This child restraint system has been classified in the „Semi-Universal" ca­
tegory according to stricter approval criteria than previous models that no
longer meet these new requirements.
•
Only suitable for vehicles with 3-point safety belt (fixed or with retractor) ac­
cording to UN/ECE Regulation No 16 or equivalent standard.
•
If in doubt, contact the manufacturer of the restraint system or your dealer.
1. Extend the Isofix connectors (B) to the maximum length using the button for
extending the Isofix connectors (C) (see Fig. 1).
2. Now guide the extended Isofix connectors to the Isofix hooks on your car
seat and press them until the Isofix connectors engage (see Fig. 2) and the
marking on the Isofix connectors switches from RED to GREEN.
3. Now you can push the child car seat as close as possible to the backrest of
your car seat (see Fig. 3).
4. Now put the child inside.
5. Fasten the child with the vehicle's 3-point seat belt and make sure that it
is properly engaged. For the belt run, please refer to the adjacent drawing.
6. Group 2 (15-25 kg): Diagonal and lap belt run under the armrest.
7. Group 3 (22-36 kg): Diagonal belt runs over, the lap belt under the armrest of
the child car seat.
8. Make sure that the belt is tight and not twisted.
1
Removal of the child car seat with Isofix bracket
1. Press the release button (C) on both sides of the child car seat and pull it
away from the backrest of your car seat.
- 10 -
2 3