Metra HYBL-04 Guia De Inicio Rapido página 2

connectIons on tHe Interface
from the 24-pin harness:
• Connect the Yellow wire to the 12-volt constant/battery wire of the aftermarket radio
• Connect the Black wire to the ground wire of the aftermarket radio
• Connect the White and red RCA to the aftermarket radios AUX input
• Connect the Blue/pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
from the 18-pin harness:
• Connect the Blue wire to the power antenna wire of the aftermarket radio.
If the aftermarket radio does not have a power antenna wire, connect this wire
to the red ignition wire.
• Connect the orange wire to the illumination wire of the aftermarket radio.
If the aftermarket radio has no illumination wire, tape off the orange wire.
Installing the HYBl-04
1. With all the connections completed, plug the 16- and 18-pin harnesses into
the HYBL-04.
2. Plug the 24- and 18-pin harness into the vehicle side harness, and plug the
aftermarket radio harness into the aftermarket radio.
3. Reconnect the negative battery terminal.
4. Turn the ignition on, but do not start the car.
5. Press and hold the volume up button on the steering wheel for 5-seconds,
this will learn BlueLink.
6. If the vehicle came equipped with factory navigation press and hold the mode
button on the steering wheel for 5-seconds (if vehicle did not come equipped
with factory navigation, skip this step).
METRA. The World's best kits.
HYBL-04
(continued)
testing and adjusting the HYBl-04
1. Turn the aftermarket radio on.
2. Set potentiometer all the way to the left.
3. Set radio to desired level.
additional 12-pin harness (asWc-1 harness)
This 12-pin harness is to be used in conjunction with the ASWC-1 (not included).
Please refer to ASWC-1 instructions for programming.
™ 1-800-221-0932
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
metraonline.com
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
Caution: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
Note: Refer to the instructions included with the
aftermarket radio.