Promaker PRO-LO180 Manual Del Usuario página 8

with nameplate marking. 120 Volts
AC only means your tool will operate
on standard 60 Hz household
power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC
means that you tool will operate on
standard 60 Hz AC or DC power.
This information is printed on the
nameplate. Lower voltage will cause
loss of power and can result in over-
heating. All PROMAKER® tools are
factory-tested; if this tool does not
operate, check the power supply
ASSEMBLY
CAUTION:To reduce the risk of
injury, turn off and unplug the tool
before making any adjustments or
removing or installing attachments
or accessories.
INSTALLING THE DUST BAG
ASSEMBLY
1. Insert the dust bag assembly (3)
into the dust chute (4) (Fig. A).
NOTE: Make sure the assembly
tabs insert into the matching slots in
the dust chute.
2. Rotate the dust bag assembly
CLOCKWISE approximately 15° to
lock it into place.
NOTE: Remove and clean the dust
bag assembly periodically to remove
accumulated dust from the dust bag.
REMOVING & CLEANING THE
DUST BAG
1. Remove dust bag assembly (3)
by rotating the dust bag assembly
approximately
clockwise and pulling it out of the
dust chute.
2. Remove the dust bag (3a) from
the dust bag support (3b) by opening
the elasticized end of the dust bag
(3c) and sliding it off the dust bag
support (Fig. B).
3. Carefully shake the dust bag with
the elasticized opening pointing
downward to remove the sanding
dust.
NOTE: It is best to perform this
function outdoors over a trash can to
15° counter-
8