Care And Maintenance; Troubleshooting - allen+roth WSWS-EP1BN Manual Del Usuario

ASSEMBLY INSTRUCTIONS
1a. If installing the item into the wall, use open pole
holder (AA) as a guide and mark screw hole locations
with a pencil. Drill 3/8 in. diameter pilot holes at least
2-1/2 inch deep at marked locations, then insert drywall
anchors (not included) into the holes until they are flush
with the wall. Attach open pole holder (AA)
screws (CC).
Note: Drywall anchors are not required if installing into a
stud.
Repeat for closed pole holder (BB).
Note: Ensure the flat edge of the open pole holder (AA) is
level before tightening the screws completely.
Hardware Used
CC Long Screw
1b. If installing the item into a cabinet (sold separately),
use open pole holder (AA) as a guide and mark screw hole
locations with a pencil. Attach open pole holder (AA)
short screws (EE).
Repeat for closed pole holder (BB).
Note: Ensure the flat edge of the open pole holder (AA) is
level before tightening the screws completely.
Hardware Used
EE
Short Screw
2. Insert 22 mm metal pole (A) into 25 mm metal pole (B).
1a
Drywall Anchor
BB
using long
CC
Drywall Anchor
CC
x 6
1b
BB
using
CC
x 3
CC
2
A
Lowes.com/allenandroth
4
3. Insert one end of the pole assembly into the
closed pole holder (BB), securing with
self-tapping screw (DD). Repeat for the opposite end.
Hardware Used
DD
AA

CARE AND MAINTENANCE

• Periodically check to make certain all components are properly positioned, free from damage and
firmly connected.
• Use a soft, clean cloth that will not scratch the surface when dusting.
• Never use water to clean the furniture as it may damage to the finish.
• Wipe clean using a damp cloth and a mild cleaner. Wipe dry with a clean cloth.
AA
• Keep product away from direct sunlight as it may damage the finish.

TROUBLESHOOTING

PROBLEM
One end of metal pole
does not rest properly
onto the open pole
holder (AA).
The pole kit is tilting.
B
The side panel of wood
cabinet is pierced.
Self-tapping Screw
x 2
POSSIBLE CAUSE
The opening of open pole holder
does not face upward vertically.
The open and closed pole holders
are not installed at the same level.
Used long screw for attaching pole
holder onto the side of cabinet.
5
3
BB
B
DD
CORRECTIVE ACTION
Use a quality level to ensure the flat
edge of the open pole holder is level
while installing.
Use a quality level to ensure the pole
holders are level with each other.
Use the short screw.
Lowes.com/allenandroth