Thermor ONIX CONNECT Manual Del Usuario página 10

EN
Installation manual: Fitting the water heater
4. Control interface (HMI)
WIFI Touch button
BOOST Mode
Absence mode
(Anti-freezing)
PLEASE NOTE: If the device is inactive for 60 seconds, the LED indicators of the Water Drop
will be turned off and the circle around the selected mode (and the WIFI LED if the product is
connected) will start to blink on the HMI. The indication on the Water Drop will be
reactivated if a button is used or if the appliance is heating.
Indicators
8
Manual Mode
Indicator status
Absence
On
(7 °C). The BOOST function is deactivated.
Manual mode selected:
On
To set the temprature of hot water, touch the buttons until the
desired level is selected on the Water Drop LEDs (5 levels available).
On ECO+ mode activated; the water heater starts reading
consumption to adapt to the needs of the user and ensure energy
savings, whilst guaranteeing comfort levels.
Segments of The BOOST function is activated by a quick press. Activating
the water drop the BOOST mode sets the heating temprature to the Max
lightening one after level for 1 hour. After the heating is done, the appliance will
another return to the mode that was selected before activation of the
BOOST mode.
Blinking Water heater pairing in progress.
On
Paired water heater connected.
The appliance is not heating water. The lit segments show the
On
quantity of the available hot water.
The appliance is heating water to reach the required level.
Blinking
The fixed lit segments show the quantity of available hot water.
Top segment is lit The appliance is malfunctioning. Check the list of error codes
in orange below or contact the after-sales services
Meaning
mode activated: The water heater is frost-protected
Available hot water and
heating indicators
(Water Drop)
ECO+ mode