Campbell Hausfeld CHN70800 Manual De Instrucciones

3-1/2 inch 34° Framing Nailer
CHN70800
Setup
Easy Setup Guide
Projects are easier with
Campbell Hausfeld products.
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects Like a Pro.
© 2009 Campbell Hausfeld/Scott Fetzer © 2009 Campbell Hausfeld/Scott Fetzer
3
Load
fasteners. See manual for further information regarding
length and type of fasteners.
Load nails into rear slot of magazine.
Setup Like a Pro
1
Visit us at chpower.com
Close
regulator,
ON
Allow
Like a Pro
maximum pressure.
NOTICE: To operate this tool you will need
IN727801AV 6/09
Pull pusher back over nail clip.
Release pusher.
2
pressure Attach
Turn hose to regulator
compressor and outlet.
tank to reach regulator knob so
outlet pressure is
between 70 psi and
120 psi.
at least a 1 gallon compressor.
4
Attach
coupler
on air hose to se to
nailer inlet. et.
air
Adjust
70 120
psi psi
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
CHN70800 — Air Powered Framing Nailer
Screw
Battery Replacement
Always disconnect the tool from
the power source when unattended,