Culligan RV-700 Instrucciones Para La Instalación Y El Funcionamiento

Recreational Vehicle/Marine
Water Filter
Installation and Operating Instructions
Models RV-700 and RV-800
Operating Specifications
Pressure Range: 30–100 psi (2.1–8.6 bar)
Temperature Range: 40–100°F (4.4–37.7°C)
Rated Service Flow: 1 gpm @ 60 psi (3.8 Lpm @ 4.1 bar)
Parts Included
Granular activated carbon filter
Plastic plugs
Hose (RV-800 only)
Precautions
WARNING: Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
CAUTION: Filter must be protected against freezing, which can cause cracking of
the filter and water leakage.
NOTE:
• Make certain that installation complies with all state and local laws and
regulations.
• For cold water use only.
• A drinking water filter cartridge may contain carbon fines (very fine black
powder). After installation flush the cartridge for 5 minutes to remove the fines
before using the water. You should run the tap at least 20 seconds prior to using
water for drinking or cooking purposes.
• The replacement filter cartridge has a service life of about 2,000 gallons or one
recreational season of use. Changes in taste, odor, color, and flow of the water
being filtered indicate that the cartridge should be replaced.
• The contaminants or other substances removed or reduced by this water
treatment device are not necessarily in your water.
Installation
• For use with 3/4-inch flexible hose couplings. It is recommended that you install
the filter between two flexible hoses to prevent it from being damaged. The short
hose supplied with the RV-800 may be attached to either end of the filter.
• Please read all precautions and instructions before installing and using your RV
water filter.
• Numbered diagrams correspond with numbered steps.
1. Turn off water supply (A). Remove plastic plugs (B) from ends of filter. DO NOT
discard plugs; they may be used to store the filter between usages. Make sure
the rubber washer (C) is inserted into inlet of filter.
NOTE: Water must flow through filter in the proper direction. INLET and OUTLET
are marked clearly on either end of the filter.
2. (A) Attach the inlet (female) end of filter to the supply hose. Turn on water (B)
and flush carbon filter (C) for 5 minutes to remove carbon fines before using the
water. Turn off water supply.
3. (A) Attach outlet (male) end of filter to second hose. Installation is complete!
Turn on water supply (B) to use filter.
TECHNICAL SUPPORT: 1-800-721-9243 Mon–Fri, 8-00 AM–4:30 PM CST.
The RV-700 and RV-800 are Tested and Certified by NSF International to
NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor.
Culligan International Company
9399 West Higgins Road
Rosemont, Illinois 60018
www.culligan.com
©2008 Culligan International Company
1
B
2
3
Customer Service M-F 8:00 a.m – 4:30 p.m. CST
Phone: 1-800-721-7360 Fax: 1-800-721-7390
International: Phone (920) 457-2720 • Fax (920) 457-7366
e-mail: customerservice@culligan.com
A
C
B
A
B
P.O. Box 1086 • Sheboygan, WI 53082-1086
e-mail: sales-marketing@culligan.com
C
A
Sales & Marketing Correspondence
Fax (920) 457-7366
01020341/01020342 03/08 Rev A