Steelcase 460 Rapport Manual Para El Reemplazo página 16

4.
Remove seat screws (A), seat hook screws and
seat hooks (B).
Note: Do not reuse screws.
5.
Unhook VBS cable by pushing tab on assembly
back with screwdriver.
NOTE: Refer to lower back lock replacement for
back lock removal.
6.
Lift old chair control from plate.
7.
Apply grease to axle bearing guide.
8.
Align new control and replace items in reverse
order.
NOTE: VBS cable end must "snap" into
housing. Cable MUST be routed such that there
is no pinching along the entire length.
4 and 5
A
6 7 8
and
B
Page 16 of 60
939504522 Rev G