Pneumatic Cylinder - Steelcase 460 Rapport Manual Para El Reemplazo

F. Pneumatic Cylinder
1.
Turn chair upside down and place on clean
padded work bench.
2.
Remove and discard base retaining clip from
the bottom of the chair base and carefully lift base
up and off the chair.
3.
Remove washer and bearing from the end of
the pneumatic cylinder and discard.
4.
Using the 3/16" flat bladed screwdriver, pry the
pneumatic cylinder out from the bottom of the chair
control column and discard.
1 2
and
3
Discard base retaining clip
4
Page 7 of 60
939504522 Rev G