Measuring Dc Current; Battery Test; Continuity Test - Steren MUL-105 Manual De Instrucciones

MEASURING DC CURRENT

1.- Connect the red testing point to the jack signaled "+VmA Ω"
and the black testing point to the jack signaled "COM".
2.- Set the dial to the VAC setting.
3.- Connect the red testing point to positive polarity and black
testing point to negative polarity, in the circuit to be measured.
4.- Read the current value. Please refers to next table:
Test
DC current
If you performs DC measures over 250mA, change the red If you performs DC measures over 250mA, change the red
testing point to +10A testing point to +10A
MEASURING DECIBELS
1.- Connect the red testing point to the jack signaled "+ VmA Ω.
)))" and the black testing point to the jack signaled "COM".
2.- Set the dial to the 10 VAC setting.
3.- Connect the testing points to the circuit to be measured and
read the dB value.

BATTERY TEST

1.- Connect the red testing point to the jack signaled "+ VmA Ω.
)))" and the black testing point to the jack signaled "COM".
2.- Set the dial to the BATT 1,5V setting.
3.- Touch the positive terminal of the battery with the red
testing point and the black testing point place it in "-" terminal of
the battery.

CONTINUITY TEST

1.- Set the dial to the ))) setting.
2.- Connect the testing points to the circuit to be measured.
3. The buzzer will sound if the circuit is a conducer.
Dimensions:
Weight:
Position
50μA
2,5mA
25mA
250mA
10A
160x88x40 mm
277g including batteries
ENGLISH-5
Factor
X1
X0,01
X0,1
X1
X1