Homeright PaintStick Manual De Instrucciones página 2

Preparing the PaintStick to Paint
1. Inspect roller cover for lint. For
best results, rinse roller cover
with water and let dry before
using.
WARNING: DO NOT REMOVE INNER
OR OUTER END CAPS WITH A
SCREWDRIVER! DAMAGE TO END
CAPS CAN OCCUR.
4. Insert roller assembly into
handle assembly and tighten
nut.
• NOTE: When inserting frame,
into handle, the washer on the
frame will not be flush with the
handle.
8. If you have a square paint can,
rest the can cover on top of the
paint can.
• NOTE: Can cover will rest
loosely on top of can.
2. Ensure the outer end cap is in the open positon by depressing PUSH
TO REMOVE side of the tab. Assemble the roller cover to the roller
frame by inserting the frame inside the inner end cap.
Push roller cover onto the roller frame until the roller cover stops.
5. Attach spatter shield by sliding
it over outer end cap and
clipping forked end onto roller
frame. Adjust to any position.
Tips for Painting with the PaintStick
• Inspect roller cover for lint before painting. If needed wash before using.
• When using the PaintStick for the first paint application, it will take most of the paint in
the PaintStick tube to saturate the roller cover.
• Keep roller moving while pushing inner handle in to prevent dripping.
• Stop pushing inner handle in if the roller starts to skid or slide.
• When painting in tight areas partially fill PaintStick. This reduces overall length of
PaintStick.
• When leaving PaintStick unattended for a longer period of time wrap roller cover in a
plastic bag.
PAINTSTICK
®
6. Insert fill tube through hole
in bottom side of paint can
cover and push in until tight
and to the ridge of the fill tube.
2
3. Lock end cap onto the roller
frame by depressing the locking
tab.
• NOTE: Pull gently on the roller
cover to ensure the roller cover
is secured to the roller frame.
7. Snap paint can cover onto paint
can.
• NOTE: The can cover will not fit
on some paint containers. To
fill the PaintStick, omit the can
cover and place fill tube directly
into container. Hold the fill tube
with hand to stabilize as needed.
ENGLISH