Audiovox Rampage ACD-25 El Manual Del Propietario página 11

If a problem should develop while operating the CD player, the following error codes may be displayed on the
LCD panel.
Indicates a mechanism error or that the disc is not loading or ejecting properly. Try re-
ER-1:
loading or pressing the Eject button again.
ER-2: Indicates an error in the microprocessor control of the CD player. Eject the disc, make sure
it is clean, undamaged, and loaded correctly (label side up). Re-load the disc and check for
proper operation or try another disc. You may also try activating the Re-Set button
unit, but this will also erase the time and pre-set memories.
Indicates excessive temperature conditions. CD play will resume when the temperature
ER-3:
returns to the normal range.
If the suggested measures do not solve the problem, contact an approved warranty station near you for
further assistance.
Size:
Operating Voltage:
Output Power:
Output Wiring:
Output Impedance:
Low-Level Output:
Tuning Range:
Sensitivity:
FM Stereo Separation:
CD Frequency Response:
CD Signal/Noise Ratio:
CD Channel Separation:
CD Distortion:
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel
spacing on AM/200 KHz. spacing on FM). Use in other areas in the world may require different channel
spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/100 KHz. FM channel spacing.
Slide the switch to the appropriate position using a small screwdriver blade. The Re-Set button
front of the chassis must then be pressed to activate the change of channel spacing.
ERROR CODES ERROR CODES
ERROR CODES ERROR CODES ERROR CODES
SPECIFICATIONS SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS
7" W x
178 mm x 50 mm x 163 mm
12 volts DC, negative ground
120 watts maximum
( 30 watts x 4 channels)
Floating-ground type designed for 4 speaker use.
Front and rear channels CANNOT be combined (bridged)
for use with 2 speakers.
RCA low-level outputs (rear channels).
Compatible with 4-8 ohm speakers.
2.0 volts (2,000 mv.)
AM: 530-1,720 KHz. (10 KHz. step)
522-1,620 KHz. (9 KHz. step)
FM: 87.5-107.9 MHz. (200 KHz. step)
87.5-108.0 MHz. (100 KHz. step)
AM: 20 uv.
FM: 1.5 uv.
30 dB
20-20,000 Hz. ±1 dB
70 dB
60 dB
0.2%
*Specifications are subject to change without notice.
FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH FREQUENCY STEP SWITCH
2" H x 6-3/8" D
cr
on the
10 10 10 10 10
cr
on the