Steren BAF-510 Manual De Instrucciones página 5

Please make sure that the power unit supplied is marked for the
correct voltage in your area. Power requirements for electrical
equipment differ from area to area. It is wise to confi rm the
voltage and use the appropriate power supply unit before
connecting it to power sources.
Speakers and Stands
Fully extend the speaker stand tripod legs and tighten the base
thumbscrew. Extend the pole of the stand to the desired height
and insert the safety pin completely through the stand hole
above the pole thumbscrew. Lower the pole so that the pin rests
on the holder and tighten the pole thumbscrew.
Setup the stands on a fl at surface where the speakers will be
located and not disturbed. Place the speakers on the stands and
position them as desired.
Facing the speakers towards any of the microphones connected
with the mixer will increase the chance of feedback.
Connect the speaker cables to the input jacks on the lower left
front panel of both the Left and Right speakers.
Connect the other end of each cable to the corresponding Left
and Right speaker outputs on the rear panel of the mixer.
Position the length of the cables so they will not be a safety
hazard to people.
Connect only the supplied speakers to the mixer. Connect only the supplied speakers to the mixer.
Inputs
Connect all sound sources to the appropriate inputs i.e.,
microphones, keyboards, CD players, karaoke machines. The
supplied microphone is ideal for vocal.
When ready to operate, plug the AC cord into the power source.
Make sure that the unit is turned off before connecting to the AC
power source to avoid possible loud transients which can dam-
age your speakers or your ears. Before turning on, connect up
the speakers and all inputs and outputs desired and turn down
the Master Volume.
ENGLISH-5