VELGE VCCH 6501.1 W Instrucciones De Instalación página 8

for 30 seconds to remind that the charcoal filter need cleaning. To set
the timer to zero keep the button T1 pressed with the aspirator switched
off, otherwise the timer will remain set on 120 hour functioning and the
reminder will occur again when the hood is switched off again.
Once the hood is switched off, after 480 hour functioning, all leds blink (2
blinks and a pause)for 30 seconds to remind that the charcoal filter need
substitute
To set the timer to zero keep the button T1 pressed with the aspirator
switched off, otherwise the timer will remain set on 120 hour functioning
and the reminder will occur again when the hood is switched off again.
MAINTENANCE
Always disconnect the hood from the mains before carrying out any
maintenance or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that
are designed to trap particles of fat contained in the fumes. The metallic
anti-grease filters must be washed at least once a month with detergent in
hot water (or in the dish-washer).
ATTENTION: the grease collected in the filters can easily catch fire and it
is therefore extremely important to clean the metallic filters on a regular
basis as per instructions.
The activated charcoal filters are designed to collect unpleasant odours in
the cooking fumes. The air is then released purified in the environment.
The charcoal filters must not be washed, but replaced 2 or 3 times a year,
depending on how much the hood is used. New filters are to be requested
directly to the manufacturer.
To substitute the metallic filters, lift the glass door and remove the
metallic filters (Fig. 3). Press the buttons (H) to remove the plates (Fig.
4-I). Now you can reach the charcoal filters, turn them, as indicated in Fig.
4, until the extractor is released and substitute them with the new ones.
Replace the plates (I), press again the buttons (H) to fix them.
The cooker hood must be cleaned frequently both internally and
www.velgehome.com
externally (at least once a month). Do not let dirt gather on the inner and
outer surfaces of the hood.
To clean the exterior of the hood do not use either acid or basic products,
or abrasive sponges.
Clean the hood with a sponge dampen in warm water and a little quantity
of neutral detergent (for example dishwasher detergent), in order to
remove possible particles of grease.
Rinse with a damp cloth, removing all the detergent carefully, following
the satin finish direction on the steel surface.
Drying is very important, especially in areas where water is particularly
hard and leaves limestone.
WARNINGS
The present instruction manual is an integral part of the appliance itself,
therefore it must be carefully kept and ALWAYS accompany it, even in
case of its assignment to another owner or user or in case the cooker hood
is moved to another installation plant.
Any eventual adjustment to the electrical system, which may be necessary
to install the cooker hood, must be carried out only by competent people.
Any repair carried out by no competent people may cause damages. For
any repair or needed technical action make reference to a Technical
Assistance Center, which is authorized to carry out the replacement of the
spare parts.
Always make sure that all the electrical parts (lights, exhaustion unit) are
disconnected when the appliance is not in use. By storms take off the main
switch of the house electrical system.
The using of the cooker hood must not be other than the use of exhausting
units for cooking damps on domestic kitchens. The manufacturer does
not accept any liability for damages caused by people, animals or things,
by installation and maintenance mistakes or by any illegitimate use.
Make sure that the voltage (V) and the frequency (Hz) ratings indicated
on the plate inside the cooker hood correspond to the ones available in the
installation place.