Security Information; System Requirements; Location Of Controls - Steren MP3-900 Manual De Instrucciones

• Use only accessories that are specifi ed by the manufacturer
• Disconnect his device during electrical storms or when the
device is not going to be used for an extended period of time
• See an authorized technician for any service this device might
need
If this device is suddenly blocked or does not respond, it could be
due to an electrostatic phenomenon. If this occurs, use the following
procedure:
1. Power the device off from the back panel
2. Power the device on from the back panel

SECURITY INFORMATION

Before operating this device, make sure the voltages indicated on
the AC cable's tags correspond with your local voltage
Place the device on a fl at, hard, and stable base.
Make sure the device is placed in an area with suffi cient
ventilation in order to prevent overheating in the system
Leave at least 10 centimeters of space between the device and the
wall from the back and the top and at least 5 centimeters from the
sides.
Do not cover the ventilation slots
Do not expose the device to excessive humidity, rain, sand, or heat
sources caused by other devices or direct sunlight.
Do not place the device near wet areas or anywhere it might get
splashed on, this device is not waterproof.
When the system is in stand-by mode, it will still consume a When the system is in stand-by mode, it will still consume a
small amount of energy. Make sure to disconnect the device if small amount of energy. Make sure to disconnect the device if
it will not be used for an extended period of time. it will not be used for an extended period of time.
4. Smart Menu
When you press this button the screen will display a specifi c function
for each of the device's buttons. This will give you direct access to
the most frequently used functions.
5. Control wheel and direction button
Use these controls in order to search, adjust the volume, and
navigate through the different available menus.
6. USB connector
Allows you to connect an external USB device
7. SD/MMC card slot
8. Infrared sensor
9. USB connector
Allows you to connect your music center to a computer through the
USB port
10 Headphones input
11 Line-in
Use this jack in order to connect an external audio device through a
3.5 mm connector
12 RCA input connectors
Use this jack in order to connect an external audio device through
an RCA connector
ENGLISH-5
ENGLISH-7
MINIMUM SYSTEM REQUIREMENTS
• Pentium 2 at 200 MHz
• 64 MB of RAM
• 500 MB available hard drive space
• USB 1.1 port
• CD/DVD drive
• Windows 98SE, 2000 (SP3), XP (SP1)

LOCATION OF CONTROLS

1. Quick Play
This function allows you to begin playback quickly. This function will
play the last 20 songs played.
2. Fill-it-up
If you have songs on your hard drive and at the same time you
connect an external device such as an MP3 player, fl ash drive, or
SD/MMC card, this button will determine the available space in that
device and will copy as many songs onto that device as is possible.
3. Source
Press this button in order to select the type of source from which you
wish to play music. This feature has 6 options:
Press this button repeatedly until you fi nd the source from which you
wish to play the music.
13 RCA output
Allows you to connect your music center to an external audio device
through an RCA connector
14 Speaker connectors
15 FM antenna connector
16 AM antenna connector
17 Power
Press once to turn the device on / Press and hold until the
equipment turns off
1
3
2
17
Line-in
Setup
Music
Radio
Card
ENGLISH-6
7
6
4
5
8
ENGLISH-8