Electrical Characteristics; General Specifications; Apéndice; Especificaciones - Yamaha MW10 Manual De Instrucciones

Appendix
Specifications

Electrical Characteristics

Total Harmonic Distortion
(MIC to ST OUT)
Frequency Response
(CH INPUT 1-9/10, RETURN, 2TR IN to
ST OUT, AUX SEND, C-R OUT, REC
OUT)
Hum & Noise
Rs=150 ohms, Gain=Maximum (CH
INPUT 1-2), Hum & Noise are measured
with a -6 dB/octave filter @12.7 kHz;
equivalent to a 20 kHz filter with infinite
dB/octave attenuation.
Maximum Voltage Gain
1 kHz, 10k ohms
PAN/BAL: panned hard left or hard right.
Crosstalk (1 kHz)
Where 0 dBu = 0.775 Vrms
Output impedance of signal generator: 150 ohms
General Specifications
Monaural/Stereo CH High Pass Filter
Monaural/Stereo CH Equalization
Turn over/roll-off frequency of shelving, 3 dB below maximum
variable level
Phantom Power
Monaural/Stereo Input PEAK Indicator
USB Audio
Included Accessories
Power Consumption
Dimensions (W × H × D)
Net Weight
Temperature Range
Conditions
(THD+N) 20 Hz - 20 kHz @ +14 dBu 10k ohms, GAIN controls at
minimum level, all level controls at nominal level
20 Hz-20 kHz, nominal output level @ 1 kHz, 10 k ohms, GAIN con-
trols at minimum level (CH INPUT 1-5/6), all level controls at nominal
level
Equivalent Input Noise (CH INPUT 1-2 MIC)
Residual Output Noise (10 k ohms (ST OUT))
ST master control at nominal level and all channel LEVEL controls at
minimum level. (ST OUT)
All channel AUX controls at minimum level. (AUX SEND)
ST master control and one channel LEVEL control at nominal level.
(CH INPUT 1, 2) (ST OUT)
CH INPUT 1, 2 MIC to CH INSERT OUT, Rs=150 ohms, GAIN con-
trols at maximum level
CH INPUT 1-5/6 MIC to ST OUT, Rs=150 ohms, GAIN controls at
maximum level
CH INPUT 1-5/6 MIC to REC OUT, Rs=150 ohms, GAIN controls at
maximum level
CH INPUT 1, 2 MIC to AUX SEND, Rs=150 ohms, GAIN controls at
maximum level, PRE
CH INPUT 1, 2 MIC to AUX SEND, Rs=150 ohms, GAIN controls at
maximum level, POST
CH INPUT 3/4-5/6 LINE to ST OUT, Rs=150 ohms, GAIN controls at
maximum level
CH INPUT 3/4-5/6 LINE to AUX SEND, Rs=150 ohms, GAIN controls
at maximum level, PRE
CH INPUT 3/4-5/6 LINE to AUX SEND, Rs=150 ohms, GAIN controls
at maximum level, POST
CH INPUT 7/8-9/10 to ST OUT, Rs=150 ohms, GAIN controls at max-
imum level
RETURN to ST OUT, Rs=150 ohms
2TR IN to ST OUT, Rs=600 ohms
Adjacent inputs
input to output
80 Hz 12 dB/octave
±15 dB (Max. Variation)
HIGH: 10 kHz (shelving)
MID: 2.5 kHz (peaking)
LOW: 100 Hz (shelving)
Supplied when Phantom +48 V switch is ON. (XLR-type input jacks)
On each channel: red indicator lights if post-EQ signal (on stereo channels, if either post-EQ signal
or post-mic-amp signal) comes within 3 dB of the clipping level.
Input/Output: 44.1/48 kHz
Power adaptor (PA-10), CD-ROM, USB cable, Owner's manual
19 W
251 mm × 65 mm × 290.5 mm
1.8 kg
Operating temperature: 0 to 40 °C, Storage temperature: -20 to 60 °C
Appendix
MIN TYP MAX
0.1
–3 0 1
–128
–100
–87
(91 dB S/N)
–85
(89 dB S/N)
–64
(68 dB S/N)
60
76
64.2
70
76
50
41
47
26
12
23.8
–70
–70
MW10 Owner's Manual
UNIT
%
dB
dBu
dBu
dBu
dBu
dBu
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
23