Mesko MS 7020 Manual De Uso página 4

18. Do not use the mop without placing the cleaning pad over the mop head. Do not use
the mop when the water tank is empty.
19. Be especially cautious when using the steam mop on the stairs.
20. Store the device inside, in upright position and in a cool and dry place.
21. When using the mop, make sure that the surface to be cleaned is well lit.
22. Never pour any cleaning solutions into the water tank. They may damage the device.
23. Never block the steam nozzles. Never use the mop on soft surfaces because the
steam nozzles may get blocked. Always clean the steam nozzles by removing all the fuzz,
hair etc.
24. Use only the attached accessories recommended by the manufacturer.
25. Never direct the steam towards people or animals.
26. Do not use the steam mop on unprotected wood surfaces. The hot steam may remove
the wax when you use the mop on waxed surfaces. Never leave the mop running on wood
surfaces for a long period of time.
27. Be careful when using the mop on vinyl floors, linoleum or any temperature-sensitive
surfaces. Always test the mop on a small floor area in an inconspicuous place. Before use,
read the floor manufacturer's instructions for cleaning to make sure that the surface may
be steam-cleaned.
28. The steam mop may be used for disinfecting floors in the bathroom, kitchen, shower,
etc. To disinfect the area, hold the running mop on the surface being cleaned for at least 8
seconds but no longer than 15 second.
29. Leaving the steam mop running in the same spot without moving it for longer than
recommended may result in accumulation of sediment. The sediment can be removed with
a descaling solution or a few drops of vinegar.
30. Steam mop should be used only on sealed floors.
DESCRIPTION OF DEVICE
A) Handle F) Body
B) Trigger G) Light indicator
H) Lower cord wrap
D) Water tank I) Upper cord wrap
ASSEMBLE AND USE
1. Attach the head (pic 1, J) to the body (pic 1, F).
2. Insert the handle (pic 1, A) into the body (pic 1, F).
3. Place the microfiber cloth (pic 1, K) on the head (pic 1, J) and fasten it by pulling the cord.
4. When using steam mop on a carpet place the head on the glider (pic 1, L).
CAUTION! Never use steam mop without the microfiber cloth pad on.
5. To remove the water tank (pic 1, D) push it up and detached from the body as shown below (pic 3).
6. Pour two measuring cups (pic 1, M) of water into the water tank (pic 1, D). The maximum capacity for the water tank is 800ml.
Caution! Never overflow the water tank, because it can cause water leakage!
7. Twist the upper cord wrap (pic 1, I) clockwise, unwarp the power cord and plug it into a grounded outlet.
8. Slowly pass over the surface to be cleaned pressing the trigger (pic 1, B) to release steam when needed. It is recommended to sweep
or vacuum floor prior using steam mop.
9. When you are done using the mop unplug the power cord from the outlet, empty the water tank and carefully remove the microfiber
cloth pad.
WARNING! The microfiber cloth pad can be very hot.
K) Microfiber cloth pad
L) Glider
J) Head
4