Metra 99-6526 Instrucciones De Instalación página 7

The following (3) wires are for multimedia/navigation radios that provide these wires.
• Connect the Green/Purple wire to the reverse wire (if applicable).
Note: This wire must be connected for the interface to activate the
Personalization Menu and the Climate Control Status to the aftermarket radio.
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Blue/Pink wire to the VSS/speed sense wire (if applicable).
• Connect the Yellow RCA jack to the rear-view camera input.
Note:The rear-view camera Input is used to display the climate control status
and personalization menu. If the aftermarket radio does not have a screen with
a rear-view camera Input, then there will be no visualization of the climate
controls status and personalization menu, which makes adjusting the climate
control impossible. An externally mounted screen could be substituted
in this situation.
From the 6526 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the female 4-pin white connector with the Gray, Gray/Black, White,
and White/Black wires to the male 4-pin connector off the 24-pin black
connector with matching wire colors.
99-6526
Connections to be made
• Connect the 4-pin female connector with the Green, Green/Black, Purple, and
Purple/Black wires to the supplied 4-pin male connector with matching colors
and stripped leads. Attach the following wires.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• If retaining the 3.5mm AUX-IN jack, connect the RCA jacks labeled "From 3.5"
to the audio AUX-IN jacks.
From the 24-Pin black interface connector:
For vehicles with the OEM rear-view camera:
• Keep connected the Yellow male RCA jack to the Yellow female RCA jack to
retain the factory rear-view camera.
For vehicles without OEM rear-view camera:
• Connect the aftermarket rear-view camera to the Yellow female RCA.
• Disregard and tape off the White/Red and White/Green wires.
From the 4-Pin black connector:
• Connect the Orange wire to the Orange on the 18-pin connector.
7