Programming Procedure - GAPOSA QC19 Manual Del Usuario

PROGRAMMING THE TRANSMITTER
The first transmitter to be programmed is called MASTER and it is the only one by means of which you
can enter the programming mode.
UP
STOP
DOWN
PROG-TX

PROGRAMMING PROCEDURE

1. Power the motor
2. Press and hold PROG-TX button of transmitter till the motor starts moving.
3. Check the motor direction (Ex. UP as shawn aside) then release the PROG-TX 5S button and
5 Sec within press the UP button of the transmitter.
4. If, on the contrary, pressing PROG-TX button the motor turns DOWNWARDS, release the PROG-TX
button and press the DOWN button of the transmitter within 5 Sec.
The MASTER transmitter is now programmed and the direction of the motor synchronized with the buttons
of the transmitter itself.
1
2
PROG-TX
The MASTER transmitter is now programmed and the direction of the motor
synchronized with the buttons of the transmitter itself.
QC 19
Remote Control Unit for shutters and awnings.
PROG-TX
3
UP
UP
DOWN
4
DOWN
STOP