GAPOSA QC19 Manual Del Usuario página 8

PROGRAM OTHER TRANSMITTERS
1. Press and hold PROG-TX button of the MASTER transmitter till the motor starts moving.
The motor is now in programming mode.
2. Press and hold PROG-TX button of the MASTER transmitter till the motor starts moving. The motor is
now in programming mode.
1
PROG-TX
RESET MEMORY
To cancel transmitters from the motor's memory, press PROG-TX and STOP buttons of the MASTER
transmitter simultaneously and release them when the motor jogs indicating that any transmitter is
cancelled.
STOP
PROG-TX
PROG-TX
RESET MEMORY WITHOUT THE MASTER TRANSMITTER
To cancel programmed transmitters without the MASTER:
1. Cut the power
2. Press simultaneously PROG-TX and STOP buttons of whatever transmitter.
3. Switch on the power till the motor jogs indicating that any transmitter is cancelled.
2
STOP
PROG-TX
PROG-TX
You can delete the memorised codes holding for about 20S the switch button
or in case the switch is not present, keeping terminals 9 and 10 connected for
the same time. When the motor jogs it indicates that any transmitter is cancelled.
QC 19
Remote Control Unit for shutters and awnings.
2a
STOP
2b
UP
3
ON
DOWN
7
8
9
10