Electrical Connection - AGP TC402 Instrucciones De Seguridad

damaged by water.
7. Drilling performed at an upward angle is prohibited.
INTRODUCTION
The machine is designed for either wet or dry core drilling in stone, concrete, masonry, ceramic, and similar
materials.
All other uses which are not for the intended purpose are prohibited.
There are quick-release adaptors which hold the core bits and make it easy to clear the cores from the bits
between holes.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
WARNING: This machine is equipped with a Portable Residual
Current Device (PRCD) also known as a Ground Fault Circuit
Interrupter (GFCI). Always use this device whenever using the
machine to reduce the risk of shock hazards. Always position
the device PRCD as close as possible to the power source.
Test and reset the PRCD device before each use. Press the "Test"
button to test. Press the "Reset" button to energize the circuit to
the machine.
WARNING!: 110V UK machines are not equipped with a PRCD portable residual current device or GFCI
ground fault circuit interrupter. The machine must always be used with an isolating transformer for
protection in case an electrical fault should occur. Use an RCD in a separate control box with one or
more socket outlets in accordance with EN 60309-2 with the earthing contact position 1 h.
ASSEMBLY
Mount the bit to the quick-release bit adapter. (See instructions below: "Mounting the core bit").
LIST OF CONTENTS
1.
Diamond core drilling machine.
2.
Quick-Release Bit Adapter (2)
3.
M22 Wrench
GB
Reset Button
6
On Lamp
Test Button