Operation; Installing The Receiver - HAMPTON BAY WINDWARD IV Guía De Uso Y Mantenimiento

Operation

Your new ceiling fan is equipped with a remote control to operate
the speed, direction, and lights. For more information on how to
install the remote control, see the remote control instructions along
with the remote control components.
Setting the code
To set the code on the remote control:
Remove the battery cover by pressing rmly on the arrow and
sliding the cover off.
Slide the code switches to your choice of either up or down.
The factory setting is up.
To set the code on the receiver:
Slide the code switches to the same position as set on your
remote control.
Replace the battery cover on the remote control.
ON
1 2 3 4
Controller Model: FAN28R-240W

Installing the receiver

WARNING: To reduce the risk of re or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements. The
electrical source and fan must be 115/120 volt, 60Hz.
Position the receiver at side up and perpendicular to the
mounting bracket (A).
Position the supply wires to the left side of the mounting bracket
(A), and position the fan wires to the right side.
Partially insert the remote control receiver (H) ( at side up) until
one end rests on the ball/downrod assembly (B).
ON
1 2 3 4
H
A
C
B
Operating the Fan Remote Control
Load 4 "AAA" 1.5v batteries (included) into the battery
compartment.
Appropriate speed settings for warm or cool weather depend on
factors such as the room size, ceiling height, and number of fans.
effect. This allows you to set your air conditioner on a warmer
setting without affecting your comfort.
the ceiling. This allows you to set your heating unit on a cooler
setting without affecting your comfort.
NOTE : Do not wait for the fan to stop to press the reverse
button. The fan will not reverse if the fan is not moving.
This device complies with part 15 of the
CAUTION:
FCC rules. Changes or modi cations not expressly
approved by the manufacturer could void your
authority to operate this equipment.
Use the FAN AUTO button to select Manual or Auto operation of
your fan.
MANUAL mode lets you control the speed using the remote control.
AUTO mode adjusts the speed automatically based on the temperature
setting that you select.
2 1