Installation; Preparing For Installation - Glacier bay 874-0101 Guía De Instalación Y Cuidado

Installation

1

Preparing for installation

CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply to the tub and
shower.
□
Verify that the hole sizes and positions of the
holes in the wall are correct：
□
The shower and tub spout outlet holes
should be 1-1/4 in. diameter.
□
The valve access hole should refer to the
step 2.
□
The recommended valve depth to the
nished wall is 2 in. min. to 2-1/2 in. max.
□
Ensure that the valve body (D) cover is ush
with the nished exterior surface of the wall.
Position the valve body (D) correctly in the
wall with the "UP" pointing up. The 8 in.
minimum from the valve body to the tub
spout is required for proper operation.
30 in.
Shower Only
48 in.
Shower Only
1 1/4 in. Diamter
1 1/4 in. Diameter
48 in.
Tub & Shower
Refer to
the step 2
D
8 in. Min.
30 in.
Tub & Shower
2
Installing the valve body and
removing the plaster guard
□
a Thin Wall Installation
"Thin Wall" are usually built up with materials
such as berglass tub surround and will be the
main source of support for the valve. The plaster
guard (L) remains attached to the valve.
□
b Thick Wall Installation
"Thick Walls" are usually built up with materials such
as cement board, drywall, tile, etc. The plaster guard
(L) is positioned so that it is ush with the nished
wall. This ensures that the valve will be at the correct
position to accept the trim. The depth for valve body
(D) in wall is measured from center of shower outlet
to nished wall surface. The accepted depth distance
is 1-1/2 in. to 2-1/2 in.. When the depth distance is
1-1/2 in. to 2 in., there will be interference between
the plaster guard and escutcheon, suggest removing
the plaster guard after the wall installation.
□
Unscrew the screws (K), and remove the plaster
guard (L).
NOTE: Be sure to position the body (D) correctly in the
wall, with the markings "UP" facing upward.
1-1/2 in. to 2-1/2 in.
Finished wall
K
7
Please contact 1-855-HD-GLACIER for further assistance.
Finished wall
D
L
L
HOMEDEPOT.COM/GLACIERBAY
D
L